EN
AR
FR
DE
IT
JA
KO
NO
PT
RU
ES
ID
TH
TR
MN
- Introduction
Introduction
The air mixer ADM128 is mainly composed of a vane air motor, a clamp assembly, a coupling, a stirring shaftand a propeller type impeller. It is suitable for a 200-1000L open container. The mixer can be fixed on the edge of the container bythe clamp. The speed of the air mixer can be adjusted by the air inflow to meet the requirements of different working conditions. Theair mixer is widely used for stirring chemical solutions such as ink, oil, glue, paint, etc.
| Mixer Model | ADM128 |
| Motor Model | HX6AM-H |
| Motor Power | 3kW |
| Motor Material | Cast Iron |
| Max. Speed | 3000rpm |
| Recommended Speed | 500-2000rpm |
| 316L Shaft Size | Φ19.05×915mm |
| 316L Impeller Diameter | 8 inches |
| Impeller Type | Propeller Type |
| Number of Impellers | 1 |
| Port Size | 1/2" NPT |
| Hose Diameter | O.D.=16mm | I.D.=12mm |
| Air Pressure | 0.4-0.8MPa |
| Max. Air Consumption | 3800L/min |
| Mounting Type | Clamping Type |
| Weight | 19kg |
| Viscosity | ＜5000cP |
| Mixing Capacity | 200-1000litres |
Notes
1. Install an automatic air line lubricator in the air line within 18 inches (0.5 meter) or as close as possible to the air motor. The lubricator needs to be installed upstream of the air motor so that the oil mist will be blown directly into the motor. Make sure the lubricator is always filled with oil.
2. Before connecting to the ports, clean the compressed air connections with low pressure air to remove any dirt or debris.
3. Always use air lines that are the same size, or larger, than the air motor inlet port (refer to port size in the specifications chart).